This replacement solution for the CRF105-4096G4096A01 is engineered as a fully compatible parallel absolute encoder, matching the original 4096×4096 multi-turn resolution and parallel signal interface. All critical mechanical and electrical parameters, including shaft dimensions, flange geometry, mounting depth, and pin assignment, are precisely aligned to support direct installation without control system changes. Through a structured customization process, this solution helps reduce replacement cost while maintaining a controlled production lead time of approximately 10–15 working days.
From a performance perspective, the encoder delivers stable and repeatable absolute position feedback under continuous industrial operation. Signal integrity remains reliable in complex automation environments, supporting long-term system accuracy. Low-volume and non-standard customization can be accommodated, making this replacement solution suitable for conveyor systems, robotic assemblies, heavy machinery, and process-line actuators where compatibility, availability, and dependable parallel output are essential.
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
