This replacement solution for the CRF105-4096G4096C07 is developed as a precise 1:1 parallel absolute encoder substitute, fully matching the original 4096×4096 multi-turn resolution and absolute positioning behavior. All mechanical and electrical parameters—including flange style, shaft dimensions, mounting depth, housing profile, and pin configuration—are accurately replicated to support direct plug-and-play installation without system modification. By optimizing the customization process, this solution helps reduce sourcing cost while keeping lead time controlled at approximately 10–15 working days.
In practical operation, the encoder delivers stable and repeatable absolute position feedback under continuous industrial use. Signal consistency and mechanical robustness support reliable performance in demanding environments. Low-volume and non-standard customization can be accommodated, making this replacement solution suitable for industrial machinery, material-handling systems, automated packaging lines, and lifting equipment that require dependable parallel feedback and predictable long-term availability.
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
