This custom replacement for the CRF66-4096G4096C25 is engineered to fully reproduce the original 4096×4096 multi-turn absolute resolution and parallel output interface. All mechanical and electrical details, including shaft diameter, flange design, housing dimensions, and connector configuration, are precisely matched to ensure direct installation without system modification. The customized production approach helps optimize replacement cost while maintaining a stable lead time of approximately 10–15 working days.
In operation, the encoder delivers accurate and repeatable multi-turn absolute feedback under continuous industrial conditions. Its robust mechanical structure and stable parallel signal output support long-term reliability and low maintenance. Low-volume and non-standard customization can be accommodated, making this custom replacement suitable for CNC machinery, automated assembly lines, wind energy systems, and material-handling equipment that require dependable absolute position feedback and predictable availability.
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
