The CRF58-4096G4096C01 OEM Encoder is developed as a direct OEM-level replacement, fully matching the original parallel interface and 4096×4096 multi-turn absolute resolution. All mechanical and electrical parameters—including flange dimensions, shaft diameter, housing structure, and connector orientation—are precisely reproduced to ensure true plug-and-play installation. This solution helps reduce replacement cost and minimizes downtime caused by long sourcing cycles. Standard production lead time is 10–15 working days, supporting both planned maintenance and urgent replacement needs.
This OEM encoder has been delivered to industrial users across Southeast Asia, the Middle East, Russia, Brazil, and Indonesia. Customers recognize its stable multi-turn feedback, durable mechanical design, and reliable long-term operation. It is well suited for industrial automation, material-handling systems, and wind energy equipment where accurate absolute position feedback and consistent performance are essential.
Technical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
