This parallel absolute encoder replacement model for the CRF66-4096G4096A13 is designed to fully match the original 4096×4096 multi-turn resolution and parallel output interface. All critical mechanical and electrical parameters, including housing dimensions, flange structure, shaft interface, and connector layout, are precisely reproduced to support direct plug-and-play installation. The replacement model is well suited for systems where the original encoder is no longer available, providing a stable and high-precision absolute feedback solution. Standard production and delivery are typically completed within 10–15 working days.
In practical applications, this encoder delivers consistent multi-turn position tracking and reliable signal output under continuous operation. Its robust mechanical design supports long-term stability in demanding industrial environments. The replacement model has been applied in CNC machinery, automated assembly lines, wind turbine systems, and general industrial automation equipment where accurate and dependable absolute position feedback is required.
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
