This parallel encoder replacement model for the CRF66-4096G4096C01 is engineered to fully match the original 4096×4096 multi-turn resolution and parallel signal output. All essential mechanical and electrical characteristics—including shaft interface, flange dimensions, housing structure, and connector orientation—are precisely reproduced to support true plug-and-play installation. The replacement model is intended for applications where the original encoder is difficult to source, while maintaining stable and accurate absolute position feedback. Typical production and delivery time is 10–15 working days.
In real-world use, this replacement model delivers reliable multi-turn positioning accuracy and consistent signal stability in continuous operation. Its robust mechanical design allows dependable performance in demanding industrial environments. The encoder is well suited for CNC machinery, automated production lines, wind energy systems, and material-handling equipment where precise and repeatable absolute feedback is essential.
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
