This custom replacement encoder for the CRF65-4096G4096C31 is engineered to fully reproduce the original 4096×4096 multi-turn resolution and parallel output configuration. All key mechanical and electrical interfaces—including shaft type, flange design, housing dimensions, mounting depth, and connector layout—are precisely matched to ensure direct plug-and-play installation. It is designed for users who require stable absolute position feedback and a dependable supply alternative when the original model is difficult to source. Typical production lead time is 10–15 working days.
This replacement has been applied successfully in regions such as the Middle East, Southeast Asia, Brazil, Russia, and Ukraine. Users report consistent multi-turn accuracy, solid mechanical construction, and reliable long-term operation. It is well suited for CNC machinery, automated production lines, wind energy systems, and a wide range of industrial automation equipment where accurate and continuous absolute feedback is essential.
Technical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
