This replacement solution for the CRF105-4096G4096C29 is engineered as a fully compatible parallel absolute encoder substitute. It preserves the original 4096×4096 multi-turn resolution and parallel output characteristics, while matching key mechanical parameters such as shaft diameter, flange interface, mounting pattern, and pin assignment. The design supports direct drop-in installation without control system changes. By optimizing the customization workflow, this solution reduces replacement cost and shortens lead time, with typical delivery completed within 10–15 working days.
Technically, the encoder provides stable and repeatable parallel signal output for applications requiring reliable absolute position feedback over extended operating cycles. Performance remains consistent under continuous industrial use. Low-volume and non-standard customization can be supported, making this replacement solution suitable for conveyor systems, automation platforms, robotics, and motion-control retrofits where fast availability and dependable operation are critical.
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
