This custom replacement for the CRF105-4096G4096D01 is engineered to accurately replicate the original 4096×4096 multi-turn absolute resolution and parallel output interface. Mechanical details such as flange dimensions, shaft tolerance, housing footprint, and connector orientation are precisely matched to support direct installation without mechanical or electrical modification. By adopting a flexible customization approach, this solution helps reduce sourcing cost while ensuring stable long-term availability. Typical production lead time is 10–15 working days, making it suitable for urgent replacement or planned system maintenance.
From a performance standpoint, the encoder delivers smooth and reliable multi-turn feedback under continuous operation. The robust mechanical structure and stable signal output support consistent accuracy with minimal maintenance. Low-volume and non-standard customization can be accommodated, allowing this custom replacement to integrate effectively into automation cells, material handling equipment, industrial lifting systems, and CNC machinery where dependable absolute position feedback is required.
Electrical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
