The OEM encoder replacement for the CRF58-4096G4096E18 is engineered to faithfully reproduce the original model’s mechanical structure and SSI communication characteristics. Through tailored customization, the encoder mirrors the existing mounting scheme, shaft parameters, electrical interface, and 4096×4096 multi-turn resolution. This guarantees full interoperability with current controllers and machine architectures, allowing direct installation without mechanical changes or control system adjustments. It is especially suitable for OEMs and end users who require long-term configuration consistency and stable product availability.
Since its introduction, this OEM encoder has been deployed in industrial facilities across Indonesia, Brazil, the Middle East, Southeast Asia, and Eastern Europe. Users value its stable signal output, reliable absolute positioning performance, and robust construction under continuous-duty conditions. With an efficient production cycle of around 15 working days, it offers a dependable and cost-effective solution for maintaining precision and system compatibility in demanding industrial environments.
Technical data
| Parameter | Value |
| Electrical data (Valid for all versions unless otherwise stated) | |
| Sensor system | GaAlAs diode, photo-transistor array, precision comparator |
| Parallel output circuits | A = Open collector, C = Darlington, D = Push pull |
| Serial outputs | Differential output to RS422 |
| SS/ ASA | Differential (opto-coupler) for data driver RS 422 |
| Parity bit | Check bit (not to RS - 22 Bit) |
| Error bit output | Data Bit (parallel and SS/ 32 Bit only) |
| Enable circuit for bus operation | Active or inactive |
| Multifunctional inputs (MFP) | Signal input 6 |
| Memory circuit (latch) | Through MFP |
| Code sense | CW or CCW |
| Supply voltage range | 11 to 26 VDC |
| Supply current | 80 mA typ. / 120 mA max. |
| Data rate | 1 to 3 kHz, depending on programming (parallel interface only) |
| Measurement position deviation | ≤ ± 238' (for 4096 pos. / 360°) |
| Disc coding | Gray code |
| Setting cycles EEPROM | ≤ 10^6 |
| Mechanical data | |
| Operating speed | 3000 rpm max. (continuous), 4000 rpm max. (short period) |
| Operating torque | 5 Ncm min. (at 1000 rpm) |
| Wind-up torque | ≤ 10 Ncm (4 Ncm - CRF 66) |
| Angular acceleration | 10^6 rad/s^2 max. |
| Inertial mass of rotor | 50 gcm^2 |
| Permissible axial and radial shift load | 250 N max. |
| Bearing life expectancy | 10^6 turns |
